Mechanical Engineering

A study of the dynamic behaviour of water transport and power output
optimisation in a waved and hybrid flow field channel of a miniature
PEMFC design using CFD.

Additively manufactured patient specific cranioplasty implants with antibiotic modifications

Analysis and design improvement on structural rigidity of automobile wheel using Finite Element Analysis

Analysis of Fatigue Characteristics on Camshaft Using Finite Element Analysis

Bicycle Safety Mechanism Design

Desiccant-Based Air Dehumidifier and Cooling System

Design Improvement on Thermal and Aerodynamic Performance of a Bicycle Helmet

Design and Analysis of Different Material of Arc Spring used in Dual Mass Flywheel

Design of a Planter Box for Agriculture Crop – Corn

Design of a Planter Box for Agriculture Crop – Paddy

Design of a Planter Box for Agriculture Crop-Wheat

Development of 3D Printing Filament from HAp Reinforced PLA/PCL Biocomposites Using Melt-blending Method

Development of 3D printing filament from oil palm empty fruit bunch fibre

Development of Composites from Waste Denim Fabric Using Different Manufacturing Methods

Dynamic behaviour of water transport and power output
optimisation in tapered channel of a miniature serpentine-parallel
hybrid proton exchange membrane fuel cell design using CFD
approach

Evaluation of the biodegradability, thermal stability, and mechanical properties of nanocellulose-chitosan film for food packaging

Investigate Effect of Compatibilizers on Polymer Blend Filament from Post-Used Styrofoam and Polyethylene for Fuse Deposition Modelling

Investigation of PCM Thermal Effectiveness towards an Optimised Design of Cooling Building Envelope

Investigation of the Blockage Correction to Improve the Accuracy of Taylor’s Low-Speed Wind Tunnel

Novel adjustable platform for camera mount

Optimization of design parameter for a hybrid photovoltaic-thermoelectric system

Optimization of slenderness ratio and geometric dimensions of the annular thermoelectric generator

Preparation and characterization of nano magnesium colloid for antibacterial application

Preparation for 3D Filament, Dimension Uniformity & 3D Printability of PLA/PCL/HAp Bio-Composite Material

Recycling Polymer Blend made from Post-used Styrofoam and High Density Polyethylene for Fuse Deposition Modelling

Reduction of Energy Consumption for a Tire Test Room Through Efficient Heat Management

Simulation of UVC Disinfection System for Public Facilities

Simulation of UVC Disinfection System in Healthcare Settings

Study of the extraction of nanocellulose using deep eutectic solvent

Study the formation of nano copper colloids using electrolysis method